October 2024: Fractal Audio's VP4 Virtual Pedalboard has been added to the wiki.
Difference between revisions of "Setup menu"
| Line 17: | Line 17: | ||
* [[Cab_block#Cabinet_modeling:_on_or_off|Cabinet Modeling]] | * [[Cab_block#Cabinet_modeling:_on_or_off|Cabinet Modeling]] | ||
* [[Amp_block#Authentic_or_idealized_controls|Tone Control Display]] | * [[Amp_block#Authentic_or_idealized_controls|Tone Control Display]] | ||
| − | * Update Pre-11.x | + | * [[Amp_block#SPEAKER_IMPEDANCE_CURVE|Update Pre-11.x Presets Spkr Imp Upon Load]] |
* Spillover | * Spillover | ||
* Effects Mix | * Effects Mix | ||
Revision as of 18:31, 11 June 2021
The Setup menu on the Axe-Fx III and FM3 gives access to important system parameters. It has the following submenus:
FC Controllers
This lets you configure connected FC-6 and FC-12 controllers. Read more. Alternatively, use the software editor.
Pedals which are connected directly to the Axe-Fx or FM3 need to be configured in the I/O menu.
Global Settings
Click on an item below for more information.
- Output EQ Type
- Power Amp Modeling
- Cabinet Modeling
- Tone Control Display
- Update Pre-11.x Presets Spkr Imp Upon Load
- Spillover
- Effects Mix
- Noisegate Offset
- Prompt On Edited Preset Change
- Display Offset
- Default Scene
- Tap Tempo
- Value Knob Push Function
- AC Line Frequency
I/O
This lets you configure all audio inputs and outputs, return levels of USB channels and SPDIF/AES, and the pedal port(s) at the rear of the hardware.
All entries are explained here: I/O menu.
IR Capture
This lets you capture impulse responses using the hardware interface.
Read more.
MIDI/Remote
This lets you configure MIDI settings and external controllers.
Read more.
Utilities
- Display: sets the brightness of the display, and the brightness and color of the logo on the Axe-Fx III Mark II.
- ADC Levels: shows the digital level of the output ports and pedal ports.
- Reset: this lets you reset the system parameters, or clear all presets, or erase all user cabs.
- USB Buffer Levels: shows the USB buffer levels.
- Version: shows the version of the installed firmware, USB firmware and FPGA.
