Search results

Create the page "Resonator effect" on this wiki! See also the search results found.

• Effects list
  The table below displays the available effect blocks per product. | Resonator (2)
  4 KB (503 words) - 14:50, 5 February 2024
• Ring Modulator block
  ==Octaver effect== For even more funky business add a Phaser or an Auto-Wah effect.
  3 KB (457 words) - 16:53, 18 April 2024
• Global blocks
  * '''Axe-Fx III''': 8 global blocks per effect instance (not all effect blocks) * '''Axe-Fx II''': 10 global blocks per effect instance
  6 KB (1,036 words) - 18:23, 22 March 2024
• Flanger block
  ...s the sweep depth but if you turn it up you'll sweep too much and ruin the effect. Always start very low and bring it up gradually. In retrospect the Depth c ...e the depth of the notches caused by the comb filtering. This can make the effect more subtle but perhaps more "organic". Deep notches aren't always desirabl
  23 KB (3,573 words) - 13:55, 20 April 2024
• Comparing the Axe-Fx III to the Axe-Fx II
  * The output level of some effects / effects types has been changed, such as Resonator and Studio Compressor * A modifier can now be attached to either a single channel of an effect block, or to all its channels. You can't use a different modifier on a sing
  10 KB (1,519 words) - 17:47, 16 April 2024
• FAMC Liquid Foot+
  # Resonator 1 # Resonator 2
  125 KB (20,342 words) - 08:20, 25 March 2022
• MIDI SysEx
  ...ect-bypass-status-info-available.html SysEx commands for retrieving Preset/Effect bypass states] ...ormation about each effect block in preset follows, using 5 bytes for each effect block in the preset
  114 KB (16,586 words) - 23:11, 24 December 2023
• Factory presets
  The presets were dialed in loud so as to be sure the Fletcher-Munson effect did not influence the sound. ...e of a piezo-equipped guitar. An LFO-controlled Pitch block reproduces the effect of a TC Mimiq pedal (double tracking). The FM3 version is simplified. FM3 a
  97 KB (15,554 words) - 23:30, 21 April 2024
• Firmware release notes - Axe-Fx III
  .... Typical plates are around 25-50%. Set to higher values to exaggerate the effect. Stereo imaging is adjustable via the Pickup Spacing parameter. ...curve resulting in a clearer low end. New algorithm now also accounts for effect of speaker impedance on transformer response.
  134 KB (21,544 words) - 17:43, 19 April 2024
• I/O connectivity and levels
  '''A:''' Many SETUP and EFFECT parameters change the gain level. Some of these are intended to change gain * The LEVEL parameter of every effect increases or decreases the overall level.
  155 KB (25,257 words) - 16:49, 16 April 2024
• Firmware release notes - Axe-Fx II
  ...s driven and is more noticeable as the MV is increased. Also note that the effect in real amps is highly dependent on the speaker. Some speaker/transformer c * Change “Thru” bypass mode so that effect input is muted. This prevents, for example, delays from creating echoes whe
  194 KB (31,845 words) - 17:59, 14 February 2024