Listening to recordings of factory presets

Forum user ccroyalsenders ("SoloAWeek" on YouTube) went through all factory presets and recorded it on video.

How to audition the factory presets yourself

If possible, use stereo studio monitors when listening to the factory presets. It makes a lot of difference and you'll hear the presets the right way.
Preset output levels can vary from preset to preset.
Some presets may include a noise gate that has been set to a threshold that may not work well with your guitar.
Some presets contain an ENH block (Enhancer) which is for stereo use only. If you're running in mono and audio output is set to “Sum L+R”, Phase cancellation may occur.
Some presets include a Delay block with the Phase Rev parameter engaged. This is a stereo-only feature. If you're running in mono and audio output mode is set to “Sum L+R”, you may not hear any delay trails because of Phase cancellation. Switch off Phase Rev or select output mode “Copy L>R” instead.
When using stereo output mode "Copy L > R" you'll lose the part of the signal that's hardwired to the right channel.

When saving your own presets you have to overwrite factory presets. You can restore the factory presets at any moment:

from onboard ROM (which contains the original three banks), or
from disk after downloading them from Support. They are also included with Axe-Edit.

The factory preset banks have been updated for firmware release 2.0x.
Bank A was updated again with the release of firmware 3.
Banks A thru C were again updated with firmware 4, are included with the firmware and available on the Support page of the web site.