Setting high and low cut in the multidelay
Revision as of 12:32, 3 July 2008 by Javajunkie (talk | contribs) (New page: In order to set the high and lo cut to the multi delay, you can apply this formula: Freg = sqrt(f_high * f_low) Q = Freq / (f_high - f_low) So, for a lowcut of 20 Hz and a hicut of 2.5 ...)
In order to set the high and lo cut to the multi delay, you can apply this formula:
Freg = sqrt(f_high * f_low)
Q = Freq / (f_high - f_low)
So, for a lowcut of 20 Hz and a hicut of 2.5 kHz:
Freq = sqrt(2500 * 20) = 224
Q = 224 / (2480) = 0.09 (0.1 is close enough)
Enter the respective results in the FREQ and Q parameters
