Axe-Fx II FAQ
NOTE: The contents of this FAQ are being migrated to a dedicated Axe-Fx II Wiki.
Contents
- 1 CONNECTING THE INPUT / INSTRUMENTS
- 2 CONNECTING THE OUTPUT / AMPLIFYING
- 2.1 How do I use it with FR amplification
- 2.2 How do I use it with my own preamp or amplifier (4CM)
- 2.3 How do I set up two separate output feeds
- 2.4 How do I set the output levels and avoid clipping
- 2.5 How do I adjust the overall tone and volume level
- 2.6 How to make my tone cut better through the mix
CONNECTING THE INPUT / INSTRUMENTS
How do I connect my guitar
- The front panel input uses a proprietary circuit and dedicated A/D converter for low noise. Always use the front input for guitar, whether wired or wireless. Source
- The front input does not disable the rear input (different from Standard/Ultra). Use the menu to select either the front or the rear for Input 1. You can leave everything plugged in. Source
- The front input impedance is 1 Mohm, or less if Input Impdance is adjusted.
- All rear analog inputs are balanced like the onboard XLR outputs. The inputs detect whether the incoming signal is balanced or not.
- Do not use speaker cable to connect to the 1/4" inputs.
How do I connect a wireless receiver
The same way as with your guitar: to the front input, to take advantage of the front input's "special sauce" for noise reduction. The rear inputs (both 1 and 2) operate at line level, the front input operates at instrument level.
How do I set the input level(s)
Instead of knobs on the front panel, there are soft Input knobs in the I/O menu. The input levels are controlled via digitally-controlled potentiometer. These work globally, not per preset. The setting doesn't affect the input gain of the Amp and Drive blocks. Source1 Source2
Can I connect a music player
Yes, connect the player to the USB slot. The signal will be mixed into the output signal. Adjust the volume on the player. Source
CONNECTING THE OUTPUT / AMPLIFYING
How do I use it with FR amplification
(tube / ss poweramp)
How do I use it with my own preamp or amplifier (4CM)
The AFXII supports unity gain when settings things up for 4CM: Four Cable Method. To obtain unity gain turn both Output knobs on the front panel fully up. Source
How do I set up two separate output feeds
- FOH
- FR
- speaker cabinet
How do I set the output levels and avoid clipping
- The XLR outputs are line-level. Source