Difference between revisions of "Yeks How Tos G2"

From Fractal Audio Wiki
Jump to navigation Jump to search
Line 41: Line 41:
  
 
='''CREATING AND EDITING PRESETS'''=
 
='''CREATING AND EDITING PRESETS'''=
 
='''EFFECTS'''=
 
  
 
='''AMP BLOCK'''=
 
='''AMP BLOCK'''=
  
 
==Where are the Warmth and Thump parameters==
 
==Where are the Warmth and Thump parameters==
These are removed from the Amp block. [http://forum.fractalaudio.com/showthread.php?t=35997&p=490168&viewfull=1#post490168 Source]
+
These are removed from the Amp block in the Axe-Fx II. [http://forum.fractalaudio.com/showthread.php?t=35997&p=490168&viewfull=1#post490168 Source]
  
 
='''CAB BLOCK'''=
 
='''CAB BLOCK'''=
Line 53: Line 51:
 
==Where is the Drive parameter==
 
==Where is the Drive parameter==
  
This was removed from the Cab block. Instead, the Amp block has a Speaker Drive parameter.  
+
This parameter has been removed from the Cab block in the Axe-Fx II. Instead, the Amp block has a Speaker Drive parameter.  
 
[http://forum.fractalaudio.com/showthread.php?t=35997&p=490168&viewfull=1#post490168 Source]
 
[http://forum.fractalaudio.com/showthread.php?t=35997&p=490168&viewfull=1#post490168 Source]
 +
 +
='''OTHER EFFECTS'''=
  
 
='''SPECIAL SOUNDS AND ROUTINGS'''=
 
='''SPECIAL SOUNDS AND ROUTINGS'''=

Revision as of 14:16, 12 May 2011

THIS PAGE IS UNDER CONSTRUCTION!

In time this page will contain questions and answers regarding the Fractal Audio Axe-Fx II. The content below is for editing purposes only at this time.


Sources:

http://www.fractalaudio.com/products-fas-axe-fx-ii-2.html http://www.fractalaudio.com/tmp/Axe-Fx_II_Product_Brief.pdf http://forum.fractalaudio.com/search.php?do=finduser&userid=7762&contenttype=vBForum_Post&showposts=1 http://forum.fractalaudio.com/search.php?do=finduser&userid=1&contenttype=vBForum_Post&showposts=1 http://forum.fractalaudio.com/search.php?do=finduser&userid=8142&contenttype=vBForum_Post&showposts=1 http://forum.fractalaudio.com/search.php?do=finduser&userid=7847&contenttype=vBForum_Post&showposts=1 http://forum.fractalaudio.com/search.php?do=finduser&userid=7936&contenttype=vBForum_Post&showposts=1 http://forum.fractalaudio.com/search.php?do=finduser&userid=8733&contenttype=vBForum_Post&showposts=1 http://wiki.fractalaudio.com/index.php?title=Yeks_How_Tos http://forum.fractalaudio.com/search.php?do=finduser&userid=7770&contenttype=vBForum_Post&showposts=1 http://forum.fractalaudio.com/showthread.php?t=35930 http://forum.fractalaudio.com/forumdisplay.php?f=61 http://forum.fractalaudio.com/showthread.php?t=35997

INTRODUCTION

GENERAL

What are the differences between 1st-generation (Standard, Ultra) and 2nd-generation (Axe-Fx II) units

Where are the units manufactured

All units are made in USA. Source

HARDWARE

FIRMWARE, SYSTEM

SOFTWARE, AXE-EDIT

AMPLIFICATION, I/O

CREATING AND EDITING PRESETS

AMP BLOCK

Where are the Warmth and Thump parameters

These are removed from the Amp block in the Axe-Fx II. Source

CAB BLOCK

Where is the Drive parameter

This parameter has been removed from the Cab block in the Axe-Fx II. Instead, the Amp block has a Speaker Drive parameter. Source

OTHER EFFECTS

SPECIAL SOUNDS AND ROUTINGS

INTERNAL CONTROLLERS, MODIFIERS

PEDALS, SWITCHES, FOOT CONTROLLERS, MIDI


OLD STUFF:

INTRODUCTION= READ THIS FIRST= GENERAL= How to keep your knowledge up-to-date== How to get started quickly (for new users)== How to make sure it is set up correctly (gig checklist)== How to try the factory presets== How to find the right factory preset== How to view and hear the unit in action== How to mount it in a rack or rackbag== AMPLIFICATION AND I/O= How to switch it on and off== How to get sound from it (basics)== How to use it with FR amplification== How to connect it to a mixing table== How to integrate a (pre)amp== How to use it with a poweramp and speaker cabinet== How to use it with a guitar amplifier== How to set it up for mono or stereo output== How to get multiple output signals== How to use it for effects only== How to connect your guitar(s)== How to use its effects loop== How to set the input level== How to set the output level and avoid clipping== How to use it with headphones== How to make a digital connection== How to mute the signal when tuning== How to adjust the overall tone and volume level== How to deal with noise== FIRMWARE, SYSTEM'= How to update its firmware== How to reset the unit== How to prevent overloading the CPU== How to save and restore stuff== How to replace the battery== SOFTWARE, AXE-EDIT= How to connect to a computer== How to use it as an audio interface== How to use Axe-Edit== How to reamp== CREATING AND EDITING PRESETS= How to edit presets on a computer== How to use presets by other users== How to create a new preset from scratch== How to create your first preset== How to make editing easier== How to copy and paste effect settings between presets== How to reset an effect to its default state== How to adjust the global effects level or the master reverb level== How to insert more than 12 effects in a preset== How to add an effect to a preset== How to use effects in a parallel row== How to put effects before or after your own preamp== How to create a master bypass switch== How to run an effect in stereo or mono== How to set the correct bypass mode for an effect== How to set the volume level of an effect== How to adjust the volume level of a preset while playing== How to boost the signal for leads== How to avoid output clipping== How to decide where to put the cab block== How to enable spillover of delay trails and reverb== How to enable global control of any effects block== How to save and recall favorite amp settings (global amp)== How to minimize gaps in the signal when switching presets== How to print presets== How to keep your presets organized== How to insert an external pedal in the routing== EFFECTS'= How to know which effects are available== AMPS== How to know which amps are simulated=== How to dial in amp settings=== How to set the Drive and Master controls=== How to use the amp tone controls (tonestack)=== How to use the Bright switch=== How to use the Boost switch=== How to use the Presence control=== How to set the amp's advanced parameters=== How to split the preamp and poweramp of an amp sim=== How to get tight bass control=== How to use a Drive block to add or control gain=== How to add a gain stage=== How to prevent crossover distortion=== How to use multiple amps in a preset=== How to solve this issue: "My tone changes when I start editing the Amp block"=== How to get controlled feedback=== CABINETS== How to choose between the stock cabinets=== How to choose between the microphone sims=== How to choose between a stereo or mono cabinet=== How to use the Air and Drive parameters=== How to use an external user cab (IR)=== How to set the speaker resonance parameter=== How to optimize your room tone as well as the FOH tone === OTHER EFFECTS== How to use this effect: Chorus and Quad-Chorus=== How to use this effect: Compressor=== How to use this effect: Crossover=== How to use this effect: Delay=== How to use this effect: Detune=== How to use this effect: Drive=== How to use this effect: Effects Loop (FXL)=== How to use this effect: Stereo Enhancer=== How to use this effect: Feedback Send/Return=== How to use this effect: Filter=== How to use this effect: Flanger=== How to use this effect: Formant=== How to use this effect: Envelope filter=== How to use this effect: Graphic Equalizer=== How to use this effect: Looper=== How to use this effect: MegaTap Delay=== How to use this effect: Mixer=== How to use this effect: Multi-Delay=== How to use this effect: Multiband Compressor=== How to use this effect: Noise Gate=== How to use this effect: Panner=== How to use this effect: Parametric Equalizer=== How to use this effect: Phaser=== How to use this effect: Pitch Shifter=== How to use this effect: Resonator=== How to use this effect: Reverb=== How to use this effect: Reversed delay=== How to use this effect: Ring Modulator=== How to use this effect: Rotary Cabinet (Leslie)=== How to use this effect: Seek wah=== How to use this effect: Synth=== How to use this effect: Tremolo=== How to use this effect: (Uni)Vibe=== How to use this effect: Vocoder=== How to use this effect: Wah=== SPECIAL SOUNDS AND ROUTINGS== How to create an automated dive bomb=== How to integrate a real talk box=== How to create the vibrato effect=== How to simulate a violin=== How to simulate multiple violins (strings)=== How to crossfade effects=== How to automate volume swells=== How to get or handle acoustic tones=== How to create U2’s Mysterious Ways effect=== How to create space(ship) and lasergun sounds=== How to simulate a flute=== How to simualte an organ=== How to get the shimmer effect=== How to simulate an E-Bow (infinite sustain)=== How to simulate the sound of a windstorm=== How to simulate a sitar or tampura=== How to create infinite reverb (freeze, hold reverb, chord-drone)=== How to simulate dropped tuning=== How to simulate sirens=== How to create automatic double-tracking (ADT)=== How to use Buzz Feiten tuning=== INTERNAL CONTROLLERS AND MODIFIERS== PEDALS, SWITCHES, FOOT CONTROLLERS, MIDI= How to get familiar with MIDI== How to configure the MIDI settings and stuff== How to handle MIDI problems== How to choose a MIDI foot controller== How to make your MIDI foot controller work== How to operate the MFC-101== How to power a MIDI foot controller through MIDI (phantom power)== How to access presets 128 and higher with a MIDI foot controller== How to switch effects on and off using a MIDI foot controller== How to activate the tuner using a MIDI foot controller== How to display the tuner on a MIDI foot controller's display== How to choose an expression pedal== How to connect and configure an expression pedal or switch== How to solve a "stuttering" expression pedal== How to turn an expression pedal into a wah== How to activate an effect automatically when moving an expression pedal== How to use a single pedal to control different effects without switching presets (dual-function pedal) == How to use a switch for global control of any effects block== How to reset a pedal when switching presets== How to mute the delay using an expression pedal or switch== How to switch between different effect settings using a single switch== How to use a pedal for volume boosts== RECORDINGS= VIDEOS'= CATEGORIZED FACTORY PRESETS=

facebook, youtube