X/Y switching

X/Y switching: owner's manual

• Axe-Fx II: 4.4 X/Y Switching
• Axe-Fx II: 9.6 X/Y Quick-Jump Assign

X/Y switching: what is it

• Cliff: "The idea behind X/Y is that people often have multiple distortion/chorus/delay/etc. pedals on their board but they rarely have more than one on at a time. So rather than creating more instances of effects, which sucks up CPU, have each instance capable of more than one sound."
• X/Y-switching occurs at block level, not on preset level.
• The X/Y state of an effect can vary per preset scene.
• There's no crossfading when switching between X and Y. If you want crossfading on the Axe-Fx II, you can use scene controllers as an alternative to X/Y switching.

X/Y switching: in Axe-Edit

• Press the "X" key on the keyboard to switch a block between X and Y.
• The X/Y-states of the blocks are displayed on the grid, without needing to select the block first.

X/Y switching: controllers and modifiers

• An assigned controller/modifier always applies to both block states: X and Y. It's not possible to have different modifier settings for X and Y.

X/Y switching: when using Recall Effect on the Axe-Fx II

• Using Recall effect on the Axe-Fx II will always import the entire effect block settings: X and Y. You can't use Recall for X or Y only. Use Axe-Edit to copy and paste the X- or Y-settings.

X/Y switching: to compare sounds and check settings on the Axe-Fx II

• X/Y is an easy way to compare sounds when tweakings. Example:
  1. Go to the Amp block, state "X".
  2. Double-click the "Y" knob on the front panel, to copy the "X" settings to "Y".
  3. Select "Y" and re-select the amp type to reset the model's advanced parameters. Or doubleclick Bypass and to reset the block entirely.
  4. Now alternate between X and Y on every tab page of the Amp block to see the differences.
• You can also do this in Axe-Edit.
• An alternative approach to comparing sounds: save a preset as a Snapshot in Axe-Edit. Select Revert to get the original sound back. Then drag and drop the snapshot file into Axe-Edit.

X/Y switching: on floor controllers

• You can configure X/Y effect blocks to engage the effect in either X or Y mode. Source Example:
  1. IA Switch 1, ON message: DELAY 1 ON, DELAY 1 X (CC#47:127, CC#106: 127)
  2. IA Switch 1, OFF message: DELAY 1 OFF, DELAY 1 X (CC#47:0, CC#106: 127)
  3. IA Switch 2, OFF message: DELAY 1 ON, DELAY 1 Y (CC#47:127, CC#106: 0)
  4. IA Switch 2, OFF message: DELAY 1 OFF, DELAY 1 Y (CC#47:0, CC#106: 0)
• Or use the controller's group/switch-link functionality.
• On the MFC-101 X is green, Y is red. If you prefer the default state to be green, use Y as the default state.

X/Y switching: tutorials

• X/Y tutorial on G66 site.