Always consult the official Owners Manuals and Guides first.
Information about the FM3 may be incomplete or wrong, it's being worked on.

Spillover

From Fractal Audio Wiki
Revision as of 21:23, 11 July 2011 by Yek (talk | contribs)
Jump to: navigation, search

Manual

Template:0 Disclaimer

Template:19.11 Setting Up Spillover

Template:19.11.1 Within a Single Preset

Template:19.11.2 Across Different Presets

User contributions

Notes

  • Spillover means that delay and/or reverb trails in the current preset will continue after switching to another preset. The support for Spillover is the same as in the 1st-generation units.
  • It is enabled globally in Global > Config. Plus: the preset you’re switching to MUST contain a Delay and/or Reverb block. You can put them in the last row on their own for example, without an input, as long as they are connected to the grid output.
  • Multi Delay and Megatap Delay don’t support spillover.
  • Spillover carries over the delay/reverb signal from a previous preset. This can cause volume bumps. For example if the previous preset contains a hi-gain amp and the second preset is a clean one with a loud delay, the carried-over trails will be that of a distorted amp and will be amplified by the delay settings in the second preset.
  • If you want spillover from the last preset and continue the same delay/reverb: don’t mute or bypass the delay and/or reverb in the second preset. These will inherit the parameters of the previous preset automatically.
  • If you want spillover from the last preset and start a new delay/reverb: that’s a bitch, read about it here.