Always consult the official Owners Manuals and Guides first.
Information about the FM3 may be incomplete or wrong, it's being worked on.

Difference between revisions of "Spillover"

From Fractal Audio Wiki
Jump to: navigation, search
Line 8: Line 8:
  
 
==Notes==
 
==Notes==
* Spillover means that delay and/or reverb trails in the current preset will continue after switching to another preset. The support for Spillover is the same as in the 1st-generation units.
 
* It is enabled globally in Global > Config. Plus: the preset you’re switching to MUST contain a Delay and/or Reverb block. You can put them in the last row on their own for example, without an input, as long as they are connected to the grid output.
 
 
* Multi Delay and Megatap Delay don’t support spillover.
 
* Multi Delay and Megatap Delay don’t support spillover.
 
* Spillover carries over the delay/reverb signal from a previous preset. This can cause volume bumps. For example if the previous preset contains a hi-gain amp and the second preset is a clean one with a loud delay, the carried-over trails will be that of a distorted amp and will be amplified by the delay settings in the second preset.
 
* Spillover carries over the delay/reverb signal from a previous preset. This can cause volume bumps. For example if the previous preset contains a hi-gain amp and the second preset is a clean one with a loud delay, the carried-over trails will be that of a distorted amp and will be amplified by the delay settings in the second preset.
* If you want spillover from the last preset and continue the same delay/reverb: don’t mute or bypass the delay and/or reverb in the second preset. These will inherit the parameters of the previous preset automatically.
 
* If you want spillover from the last preset and start a new delay/reverb: that’s a bitch, read about it here.
 
  
 
[[category:Effect blocks]]
 
[[category:Effect blocks]]
 
[[category:Presets]]
 
[[category:Presets]]

Revision as of 21:28, 11 July 2011

Manual

Template:0 Disclaimer

Template:16.11 Setting Up Spillover

User contributions

Notes

  • Multi Delay and Megatap Delay don’t support spillover.
  • Spillover carries over the delay/reverb signal from a previous preset. This can cause volume bumps. For example if the previous preset contains a hi-gain amp and the second preset is a clean one with a loud delay, the carried-over trails will be that of a distorted amp and will be amplified by the delay settings in the second preset.