Always consult the official Owners Manuals and Guides first.
Information about the FM3 may be incomplete or wrong, it's being worked on.
Available on which Fractal Audio products
- Axe-Fx III: 2 blocks
- Axe-Fx II: 2 blocks
- AX8: 1 block
- FX8: 2 blocks
X/Y and channels
- Axe-Fx III: 4 channels
- Axe-Fx II: X/Y
- AX8: X/Y
- FX8: X/Y
The Uni-Vibe effect is available as a special mode of the Phaser block. Engage the Vibe mode (or select the Classic Vibe type).
The default settings are modeled after the Fulltone Deja-Vibe. source
Put the effect before the Amp block.
"You need it before the amp if you want the bump." source
Connect a pedal or switch to the Rate parameter to control speed.
Barber Pole Phaser
Like the "Shepard" tone, this creates the illusion of a never-ending upwards cycle. Works best when placed at the end of the chain.
Mono or stereo output
Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting and place it after Drive, Amp and Cab.
|Parameter||Axe-Fx III||Axe-Fx II||AX8, FX8|
|Vibe - Bulb Bias||yes|
|LFO Reset on Bypass||yes|
"Phasers cause notches in the spectrum which can reduce the apparent volume. It depends on the frequency content. Overdriven sounds have more content and will be affected more. The Level knob allows you to compensate for this."
Increase the Order parameter to simulate phasers such as the EHX Small stone and Mu-tron Bi-Phase.
"There is no feedback on a Script 90." source
LFO Bypass Reset
If LFO Bypass Reset is set to anything other than Off, the LFO will be reset to the selected phase whenever the block is bypassed. This allows synchronizing the sweep to the engagement of the effect.
Thump when engaging the Phaser
If engaging/bypassing the Phaser block causes an audible thump, change input impedance to 1M (Axe-Fx II, III and FX8).