Always consult the official Owners Manuals first
Difference between revisions of "Phaser block"
Jump to navigation
Jump to search
| Line 4: | Line 4: | ||
* [[media:5.23 Phaser -PHA-.pdf |Axe-Fx II: 5.23 Phaser [PHA]]] | * [[media:5.23 Phaser -PHA-.pdf |Axe-Fx II: 5.23 Phaser [PHA]]] | ||
| − | =Phaser: stereo | + | =Phaser: stereo or mono= |
* Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks. | * Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks. | ||
| − | =Phaser: | + | =Phaser: Feedback Tap parameter= |
* Cliff: "There is no feedback on a Script 90." [http://forum.fractalaudio.com/axe-fx-ii-bugs/52270-phaser-type-feedback-tap-incorrect-script-90-type.html#post669003 source] | * Cliff: "There is no feedback on a Script 90." [http://forum.fractalaudio.com/axe-fx-ii-bugs/52270-phaser-type-feedback-tap-incorrect-script-90-type.html#post669003 source] | ||
Revision as of 18:03, 1 April 2015
Contents
Phaser: in the owner's manual
Phaser: stereo or mono
- Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks.
Phaser: Feedback Tap parameter
- Cliff: "There is no feedback on a Script 90." source
Phaser: preventing thump when engaging
- If engaging/bypassing the Phaser block causes an audible thump or gap, change Input Impedance to 1M.
Phaser: Uni-vibe effect
- The Vibe effect is a special mode of the Phaser block. Set Vibe Mode to On (or select the Classic Vibe type).
- Tip: connect a pedal or switch (via an external controller) to the Rate parameter to control speed.
- This thread contains excellent Robin Trower vibe settings
Phaser: Barber pole
- This phaser type works best when placed at the end of the chain.
