|
Tag: Redirect target changed |
| (279 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | =Manual=
| + | #redirect [[Noise gate#Gate/Expander block]] |
| | | | |
| − | {{5.34 Input Noise Gate}}
| + | [[category:Axe-Fx2]] |
| − | {{5.14 Gate/Expander (GTE)}}
| + | [[category:Axe-Fx3]] |
| − | | + | [[category:FM3]] |
| − | =User contributions=
| + | [[category:FM9]] |
| − | | + | [[category:AX8]] |
| − | ==More information about the noise gate==
| + | [[category:FX8]] |
| − | * Cliff: "I don't use the gate at all. On the Ultra I would use the gate on high gain patches but I find I don't need it now. I did some measurements and the II is at least 10 dB better SNR." [http://forum.fractalaudio.com/axe-fx-ii-discussion/41117-funny-thing-rehersal.html#post552329 Source]
| + | [[category:Sounds]] |
| − | * Firmware 5 release notes: "New gate uses dynamic filtering in addition to downward expansion."
| + | [[category:All]] |
| − | * [http://en.wikipedia.org/wiki/Noise_gate Wikipedia]
| |
| − | | |
| − | ==Settings and parameters==
| |
| − | * The Input Noise Gate on the II works different than on the Standard/Ultra. Adjusting Threshold won't do anything if Ratio isn't adjusted as well.
| |
| − | * Cliff (firmware 10): "I DID change the default attack time. For a guitar gate you typically want the attack time as short as possible and I don't think people realize this so I changed the default value." [http://forum.fractalaudio.com/axe-fx-ii-discussion/67381-has-gate-been-improved-just-way-amps-interact.html#post829960 Source]
| |
| − | * Firmware 11 and later have made it possible to save noise gate settings as global blocks.
| |
| − | | |
| − | ==Level==
| |
| − | * Firmware 11: "Added Level parameter to Noise Gate. This allows sending a lower or higher level into the effects grid which can be used to compensate for guitars with varying output."
| |
| − | | |
| − | ==CPU utilization==
| |
| − | * The Noise Gate uses CPU cycles, so switch it off (turn Threshold to Off) if you have no need for it in a preset.
| |
| − | | |
| − | ==Gate/Expander alternative==
| |
| − | * The Axe-Fx II has additional noise gate blocks: [[Gate/Expander (block)]].
| |
| − | | |
| − | ==Alternative: use a Vol block==
| |
| − | * A different approach to keeping the noise low: try a Vol block with the volume parameter tied to the Envelope controller. As long as you don't hit the strings, the (input) signal is off.
| |
| − | | |
| − | [[category:Connecting instruments and devices]] | |
| − | [[category:Presets and effects]] | |
