Phaser block

Phaser: in the owner's manual

• Axe-Fx II: 5.23 Phaser [PHA]

Phaser: stereo/mono

• Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks.

Phaser: feedback tap parameter

• Cliff: "There is no feedback on a Script 90." source

Phaser: preventing thump when engaging

• If engaging/bypassing the Phaser block causes an audible thump or gap, change Input Impedance to 1M.

Phaser: Uni-vibe effect

• The Vibe effect is a special mode of the Phaser block. Set Vibe Mode to On (or select the Classic Vibe type).
• Tip: connect a pedal or switch (via an external controller) to the Rate parameter to control speed.
• This thread contains excellent Robin Trower vibe settings

Phaser: Barber pole

• This phaser type works best when placed at the end of the chain.

Phaser: more information and tips

• FX8 and Axe-Fx II Effeets threads: Modulation (PHA CHO FLA ROT RNG PAN ENH)
• Phaser in Wikipedia
• Uni-Vibe in Wikipedia