Volume/Panner block

User contributions

Automating volume swells

• To make the volume level rise automatically (based on the Boss Slow Gear pedal), use a Volume block with an envelope modifier. Copy the Vol block and Envelope settings from a factory preset, such as Auto Swell Pongverb, Ganymede or Atmosphere.
• Alternatively, for say Van Halen's Cathedral effect, set the noise gate to a low threshold, ratio to around 4 and turn down the volume on your guitar.

Tapers

• The VOL block offers various audio tapers.
• Firmware 8.00: "Added Log 20A and Log 5A taper options to Volume block."
• "The number is the percentage at the halfway point. I.e. Log 20A means that the resistance is 20% at the halfway point in the travel. So if you put the knob at noon, the volume would be 20% of maximum (about -14 dB)." Source
• To simulate a Log taper in a modifier menu, set "Mid" in the Input Gain's modifier menu to 20%. Adjust Slope to avoid the dead zone.

Using the Vol block as a noise gate

• This thread offers a different approach to keeping the noise low. It's a Vol block with the volume parameter tied to the Envelope controller. As long as you don't hit the strings, the (input) signal is off.

Simulating other effects

• Mother-of-all-pedal-and-effects-emulations thread