The VP4 has been added to the wiki.
Difference between revisions of "Enhancer block"
Line 48: | Line 48: | ||
* [http://forum.fractalaudio.com/threads/double-tracking-effect-on-live-guitar.119376/unread live double tracking.] | * [http://forum.fractalaudio.com/threads/double-tracking-effect-on-live-guitar.119376/unread live double tracking.] | ||
− | [[category:Axe- | + | [[category:Axe-Fx2]] |
+ | [[category:Axe-Fx3]] | ||
[[category:FX8]] | [[category:FX8]] | ||
[[category:AX8]] | [[category:AX8]] | ||
[[category:Sounds]] | [[category:Sounds]] |
Revision as of 09:16, 13 March 2018
The information on this page supplements the official manuals.
Contents
Image to be added
Stereo Enhancer: supported by which Fractal Audio products
- Axe-Fx III: 2x.
- Axe-Fx II: 1x.
- FX8: 1x.
- AX8: 1x.
Stereo Enhancer: X/Y switching or channels
- Axe-Fx III: 2 channels.
- Axe-Fx II: no.
- FX8: no.
- AX8: no.
Classic or Modern mode
- Classic: old Haas effect delay-based processing. Haas effect in Wikipedia.
- Modern: multi-band techniques for a much more natural effect. Also, the effect is mono-compatible with no phasing problems when summing to mono. The effect both widens stereo signals and “stereoizes” mono signals. Low-cut and High-cut parameters allow control over the region of influence. It is NOT recommended to use the Enhancer if just using one side of a stereo output as phasing effects may be encountered. More information.
"Classic enhancer mode is just a delay on one side (adjustable from 0 to 20 ms) plus pan & phase adjustment. The non-delayed side will tend to seem louder, just like if you used a delay block to get the same delay time." Bakerman
Input and output: mono/stereo
- Output: The Enhancer only works with stereo output. Also, don't use it if you only use one channel (left or right) of a stereo signal.
- Input: While a stereo input signal works best, the Enhancer can also "stereoize" an incoming mono signal. Of course, the output signal still has to be stereo.
Tips and tricks
Widen the Panner
Make the stereo Panner (Tremolo/Panner block) effect appear fuller and wider by adding the Enhancer.
Alternatives to Stereo Enhancer
"Another way would be to use the Delay block. Set the Mix to 100%, dial in the desired amount of delay and set Balance to full right." source
Troubleshooting
Avoid phase cancellation and comb filtering
When summing a stereo signal to mono, the Enhancer in Classic mode can cause phase cancellation. The Modern Mode is mono-compatible to prevent this.
"Never put the enhancer in parallel or you'll get phasing problems. That's why there is no bypass mode because it should always be in series." source
"The Modern Enhancer will survive collapsing to mono but any enhancer should be used judiciously, especially for recordings." source