Read the Owners Manual first!
Difference between revisions of "Phaser block"
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
=Phaser: feedback tap parameter= | =Phaser: feedback tap parameter= | ||
| − | * Cliff: "There is no feedback on a Script 90." [http://forum.fractalaudio.com/axe-fx-ii-bugs/52270-phaser-type-feedback-tap-incorrect-script-90-type.html#post669003 | + | * Cliff: "There is no feedback on a Script 90." [http://forum.fractalaudio.com/axe-fx-ii-bugs/52270-phaser-type-feedback-tap-incorrect-script-90-type.html#post669003 source] |
=Phaser: preventing thump when engaging= | =Phaser: preventing thump when engaging= | ||
Revision as of 12:48, 29 March 2015
Contents
Phaser: in the owner's manual
Phaser: stereo/mono
- Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks.
Phaser: feedback tap parameter
- Cliff: "There is no feedback on a Script 90." source
Phaser: preventing thump when engaging
- If engaging/bypassing the Phaser block causes an audible thump or gap, change Input Impedance to 1M.
Phaser: Uni-vibe effect
- The Vibe effect (Wikipedia) is a special mode of the Phaser block. Set Vibe Mode to On (or select the Classic Vibe type).
- Tip: connect a pedal or switch (via an external controller) to the Rate parameter to control speed.
- This thread contains excellent Robin Trower vibe settings.
Phaser: Barber pole
- This phaser type works best when placed at the end of the chain.
