Revision as of 11:06, 24 October 2012

Manual

User: "I have two patches that both has delay blocks disabled and when I switch between these patches via MFC the delay spillover sometimes kicks in really loud." Cliff: "This can happen if you rapidly switch between presets many times. The unit requires a small amount of time between preset changes to clear unused buffer space. This is done as a background task." Source

If you use Mix and Level to dial in the effects level, the volume level of the reverb and/or delay trails may change when switching presets. This can be prevented by keeping Mix and Level at fixed values, and using Input Gain to set the desired effects level. Source

@@ Line 14: / Line 14: @@
 ==Keeping level changes when switching presets==
-If you use Mix and Level to dial in the effects level, the volume level of the reverb and/or delay trails may change when switching presets. This can be prevented by keeping Mix and Level at fixed values, and using Input Gain to set the desired effects level. [http://forum.fractalaudio.com/ultra-std-discussion/42536-adding-parallel-rows-grid-increases-volume.html#post565766 Source]
+* If you use Mix and Level to dial in the effects level, the volume level of the reverb and/or delay trails may change when switching presets. This can be prevented by keeping Mix and Level at fixed values, and using Input Gain to set the desired effects level. [http://forum.fractalaudio.com/ultra-std-discussion/42536-adding-parallel-rows-grid-increases-volume.html#post565766 Source]
 ==Wicked Wiki==
-Additional information in [http://forum.fractalaudio.com/axe-fx-ii-discussion/49144-wicked-wiki-1-optimizing-spillover.html?highlight=wicked+wiki this Wicked Wiki thread].
+* Additional information in [http://forum.fractalaudio.com/axe-fx-ii-discussion/49144-wicked-wiki-1-optimizing-spillover.html?highlight=wicked+wiki this Wicked Wiki thread].
 [[category:Presets and effects]]