October 2024: Fractal Audio's VP4 Virtual Pedalboard has been added to the wiki.
Difference between revisions of "Realtime Analyzer block"
| Line 44: | Line 44: | ||
=Parameters= | =Parameters= | ||
| + | |||
| + | =Parameters table= | ||
{| class="wikitable" | {| class="wikitable" | ||
| Line 62: | Line 64: | ||
! yes | ! yes | ||
|} | |} | ||
| + | |||
| + | ==Decay Time== | ||
| + | |||
| + | To make the peaks remain longer visible, adjust Decay Time. | ||
| + | |||
| + | ==Value knob== | ||
| + | |||
| + | Turn the Value knob to select the desired band, and the frequency of the selected band will be displayed in the upper left corner. | ||
[[category:Axe-Fx3]] | [[category:Axe-Fx3]] | ||
[[category:FM3]] | [[category:FM3]] | ||
[[category:Sounds]] | [[category:Sounds]] | ||
Revision as of 13:03, 22 August 2019
Contents
Available on which products
- Axe-Fx III: 1 block
- FM3: yes
- Axe-Fx II: no
- AX8: no
- FX8: no
Channels or X/Y switching
- Axe-Fx III and FM3: no
Purpose
The RTA provides detailed visual feedback of the audio spectrum. Possible uses are described below.
To view the display, scroll to the RTA block and press Edit. It makes for a great display during performances. Many users just use it because it looks pretty and dynamic.
It can point out frequencies where undesired feedback occurs. You can then use a PEQ to cut those frequencies.
“Use it to identify problem frequencies or as a spiffy screen saver.” source
It can used to test the hardware I/O. For example, to test the Instrument input: (source)
- Go to a blank preset
- Create a chain that connects Input 1 to the RTA block. On a separate row create a chain where the Synth block feeds Output 3
- Set the Synth Type = Sine, Tracking = Off, Frequency = 1000 Hz
- Connect an instrument cable from Output 3 (left or right) to the Instrument Input
- Set the Input 1 / Instrument A/D Input Level (Home->Setup->I/O) to 50%
- Turn the Out 3 Level knob all the way up
- The Input 1 yellow LED should be lit. Red should not be lit. Go to the RTA block Config tab. Set Bands to 128, Window to Blackman. Go to the RTA tab. There should be a narrow spike at 1 kHz (three bands). There should be no other bands showing power except maybe a little noise at the highest bands. The spike at 1 kHz should be about 2 1/4 divisions below full-scale
It can be used to measure the output of other equipment, in conjunction with the Synth block. For example, to measure the frequency response of an external EQ or distortion pedal, set the Synth block to Pink Noise, send the Synth's signal through the pedal and back again, and use the RTA to measure and see the response.
Position of the RTA on the grid
The RTA block requires an input signal and doesn't send a signal out, so its output doesn't need to be connected.
Parameters
Parameters table
| Parameter | Axe-Fx III / FM3 |
|---|---|
| Decay Time | yes |
| Input Select | yes |
| Bands | yes |
| Window Type | yes |
Decay Time
To make the peaks remain longer visible, adjust Decay Time.
Value knob
Turn the Value knob to select the desired band, and the frequency of the selected band will be displayed in the upper left corner.
