October 2024: Fractal Audio's VP4 Virtual Pedalboard has been added to the wiki.
Difference between revisions of "Looper block"
| Line 14: | Line 14: | ||
==Surviving preset switching== | ==Surviving preset switching== | ||
| − | + | The loop buffer will be erased upon presets switches, unless Spillover is enabled. If the preset you're switching to also has a Looper in loop mode, you can continue to control the looper. | |
==Handy tool for dialing in tones== | ==Handy tool for dialing in tones== | ||
Revision as of 12:59, 8 July 2011
Contents
Manual
User contributions
Features
- The Looper on the Axe-Fx II is a separate effect block (instead of a Delay mode as on the Standard/Ultra). It has the same features as on the Ultra (with Stack and Reverse) but with 60 seconds loop time. Source
Using switches
Go to I/O > Ctrl to assign the looper controls (such as Play and Record) to switches on a floor controller. Use a latching switch for Play/Stop and momentary switches for Record, Stack and Play Once.
Surviving preset switching
The loop buffer will be erased upon presets switches, unless Spillover is enabled. If the preset you're switching to also has a Looper in loop mode, you can continue to control the looper.
Handy tool for dialing in tones
Use the Looper when dialing in sounds. Place it before before the Amp block, and record a "unamped" guitar tone. Now keep playing it back while adjusting amp settings. You'll hear the differences in real time. Alternatively, use it to compare two sounds. Place it after the Amp block and record. Start tweaking. When you want to hear the original tone, play back the sample.
