October 2024: Fractal Audio's VP4 Virtual Pedalboard has been added to the wiki.
Difference between revisions of "X-Load Reactive Load LB-2"
| Line 1: | Line 1: | ||
| − | <font color=red>THIS PAGE IS UNDER CONSTRUCTION | + | <font color=red>THIS PAGE IS UNDER CONSTRUCTION</font> |
''The information on this page supplements the official manuals.'' | ''The information on this page supplements the official manuals.'' | ||
Revision as of 19:05, 13 February 2018
THIS PAGE IS UNDER CONSTRUCTION
The information on this page supplements the official manuals.
- http://forum.fractalaudio.com/threads/in-the-spirit-of-namm-anouncements.123378/
- http://forum.fractalaudio.com/threads/recording-tube-head-with-axe-fx-cab-sims.119956/#post-1427584
- http://forum.fractalaudio.com/threads/fractal-load-box-d.120414/#post-1433284
- http://forum.fractalaudio.com/threads/in-the-spirit-of-namm-anouncements.123378/page-8#post-1486352
The X-Load LB-2 Load Box represents the pinnacle of speaker emulation technology for live use or recording. It allows you to use a traditional tube amp without connecting a speaker cabinet. The X-Load LB-2 provides an 8Ω load (100W maximum) while outputting a balanced or unbalanced line level signal.
Unlike other load boxes and attenuators the X-Load LB-2 uses Fractal Audio Systems' Dynamic Impedance™ technology to create a level of realism never achievable before. Record your amp in its sweet spot without deafening volume, or get great tone consistently without the hassles of a speaker cab and microphone setup.
It is important to note that the X-Load LB-2 does NOT simulate the characteristic sound of a loudspeaker. This is done by routing your DI Amp signal through speaker simulation hardware—like that found in our award-winning Axe-Fx or AX8 products—or software, like our Cab-Lab application/plugin.
The X-Load LB-2 features a Speaker Thru jack so you can connect a real speaker while also feeding line signal to a recorder or speaker simulator.
The Voicing switch shifts the resonance of the load. The “UK” setting is characteristic of the typical British guitar speaker, while the “US” position replicate the lower resonance of a typical American guitar speakers.
WARNING: The LB-2 is an 8 ohm device. Be sure to connect its Amp In jack to the proper output on your amplifier to avoid damage. Mismatching impedance can result in damage to your amp. The maximum power rating of the LB-2 is 100W. Do not connect the LB-2 to any amplifier that is rated greater than 100W as this can damage the unit and/or the amp.
