USB

User comments

USB

The Axe-Fx II supports via USB:

• Editing and remote control via Axe-Edit (no MIDI interface required).
• Audio communication (no audio interface required, except when using analog audio).
• Use as an exclusive USB-to-MIDI interface for other products (in I/O > MIDI set USB ADAPTER MODE to ON).

Editing and recording can be done simultaneously.

Drivers

• Drivers for Mac and PC which add USB support are available for download here.
• The USB driver's control panel should not be used for configuration. Error messages when clicking on those can be ignored. Source

Latency

• When monitoring audio via the Axe-Fx II there's no latency.
• When monitoring the audio signal via the computer's output, latency is determined by the computer's capabilities. Source

Noise

High-pitched noise may be caused by a ground loop. Cliff: "The USB spec calls for grounding the cable at both ends (mistake). This can create a ground loop. Make sure everything is plugged into the same outlet strip." Source

Dry tracks

If you're recording with the use of an application which uses the system selected input (all 4 channels), you will end up with a recording that also contains the dry tracks. The Axe-Fx II currently doesn't let you mute the dry tracks. Source

USB media

The Axe-Fx II cannot connect to a USB stick. Source