Revision as of 11:16, 5 May 2015

Mono/stereo: in the Axe-Fx II owner's manual

There will always be discussions. Here's an example. The Axe-Fx II sounds gloriously in stereo. However, when it comes to FOH sound, stereo separation may not translate very well to a live audience, because people seldom are in the right spot to hear both sides equally well.

Flanger, Chorus and Phaser are set to mono by default. Use the parameter LFO Phase to switch the effect to stereo.
Everything before an AMP block or Drive block will be summed to mono.
When placing a Cab block at the end of the grid, the output signal will be summed to mono, unless the Cab is set to Stereo mode (or when two mono Cab blocks are used in parallel). When a Cab block is set to Stereo mode, but it is followed by a mono effect such as Drive, the resulting signal is also summed to mono.

@@ Line 1: / Line 1: @@
 [[image:monostereo.png|link=]]
-=Mono/stereo: in the owner's manual=
+=Mono/stereo: in the Axe-Fx II owner's manual=
-* [[media:5.9 Enhancer -ENH-.pdf|Axe-Fx II: 5.9 Enhancer [ENH]]]
+* 5.9 Enhancer [ENH]
-* [[media:9 Input-Output Parameters.pdf|Axe-Fx II: 9.2 Audio Parameters]]
+* 9.2 Audio Parameters
-* [[media:16.10 Mono and Stereo.pdf|Axe-Fx II:16.10 Mono and Stereo]]
+* 16.10 Mono and Stereo
 =Mono/stereo: what's best?=
@@ Line 11: / Line 11: @@
 =Mono/stereo: different mode for each output=
 * The Axe-Fx II allows different mono/stereo modes (I/O menu) for each output.
+* Sum L+R and Copy L>R are mono modes.
 =Mono/stereo: effect blocks=