October 2024: Fractal Audio's VP4 Virtual Pedalboard has been added to the wiki.
Difference between revisions of "Mono and stereo"
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
==Mono/stereo== | ==Mono/stereo== | ||
| − | * There always be discussions | + | * There will always be discussions. [http://forum.fractalaudio.com/axe-fx-ii-discussion/57659-venue-soundguy-what-reactions-have-you-had-regarding-stereo-setup-new-post.html Here's an example]). The Axe-Fx II sounds gloriously in stereo. However, when it comes to FOH sound, stereo separation may not translate very well to a live audience, because people seldom are in the right spot to hear both sides equally well. |
==Mono/stereo: different mode for each output== | ==Mono/stereo: different mode for each output== | ||
| − | * The Axe-Fx II allows different mono/stereo modes | + | * The Axe-Fx II allows different mono/stereo modes (I/O menu) for each output. |
==Mono/stereo: effect blocks== | ==Mono/stereo: effect blocks== | ||
* Flanger, Chorus and Phaser are set to mono by default. Use the parameter LFO Phase to switch the effect to stereo. | * Flanger, Chorus and Phaser are set to mono by default. Use the parameter LFO Phase to switch the effect to stereo. | ||
| − | * Everything before an | + | * Everything before an AMP block or Drive block will be summed to mono. |
* When placing a Cab block at the end of the grid, the output signal will be summed to mono, unless the Cab is set to Stereo mode (or when two mono Cab blocks are used in parallel). When a Cab block is set to Stereo mode, but it is followed by a mono effect such as Drive, the resulting signal is also summed to mono. | * When placing a Cab block at the end of the grid, the output signal will be summed to mono, unless the Cab is set to Stereo mode (or when two mono Cab blocks are used in parallel). When a Cab block is set to Stereo mode, but it is followed by a mono effect such as Drive, the resulting signal is also summed to mono. | ||
Revision as of 11:30, 15 March 2015
Contents
Manual
User contributions
Mono/stereo
- There will always be discussions. Here's an example). The Axe-Fx II sounds gloriously in stereo. However, when it comes to FOH sound, stereo separation may not translate very well to a live audience, because people seldom are in the right spot to hear both sides equally well.
Mono/stereo: different mode for each output
- The Axe-Fx II allows different mono/stereo modes (I/O menu) for each output.
Mono/stereo: effect blocks
- Flanger, Chorus and Phaser are set to mono by default. Use the parameter LFO Phase to switch the effect to stereo.
- Everything before an AMP block or Drive block will be summed to mono.
- When placing a Cab block at the end of the grid, the output signal will be summed to mono, unless the Cab is set to Stereo mode (or when two mono Cab blocks are used in parallel). When a Cab block is set to Stereo mode, but it is followed by a mono effect such as Drive, the resulting signal is also summed to mono.
Mono/stereo: phase cancellation
- Summing a stereo signal to mono may cause phase cancellation.
