Read the Owners Manual first!
Difference between revisions of "MFC-101 MIDI foot controller (legacy)"
Jump to navigation
Jump to search
| Line 17: | Line 17: | ||
** Requires separate firmware. | ** Requires separate firmware. | ||
| − | ==Accessories== | + | ==Accessories for MFC-101== |
* Go to [[Hardware accessories]] to find sources for cables, labels etc. | * Go to [[Hardware accessories]] to find sources for cables, labels etc. | ||
| − | == | + | ==MFC-101 pedalboard pictures== |
* [http://forum.fractalaudio.com/mfc-discussion/29984-show-us-your-mfc-setups-post-your-pix.html This thread] shows pictures of pedalboards of MFC-101 owners. | * [http://forum.fractalaudio.com/mfc-discussion/29984-show-us-your-mfc-setups-post-your-pix.html This thread] shows pictures of pedalboards of MFC-101 owners. | ||
Revision as of 09:32, 29 January 2014
Contents
Product information
Manuals
Mark I, Mark II and Mark III models
- Changes in Mark II:
- Cliff: "The only change is the CAT-5 connector is now an Ethercon jack. An Ethercon jack will work with either a CAT-5 cable or an Ethercon cable." Source
- Changes in Mark III:
- Solid-State switch technology. No moving parts except a spring "actuator". Switching is fully electronic and silent with no switches to wear out. Mechanical lifespan 1 million actuations.
- "FASLINK" jack: a new, proprietary communications link that features bi-directional MIDI and power over a standard XLR microphone cable. Cable runs of hundreds of feet are possible. You need a FASLINK adapter (XA-1) to convert XLR to Ethernet/Ethercon on the Axe-Fx side, or use the Axe-Fx II XL with built-in FASLINK connection. If you want to use a XLR cable with MFC-101 Mark I/II models, you also need a FASLINK adapter (XA-2) at the MFC side.
- Requires separate firmware.
Accessories for MFC-101
- Go to Hardware accessories to find sources for cables, labels etc.
MFC-101 pedalboard pictures
- This thread shows pictures of pedalboards of MFC-101 owners.
