October 2024: Fractal Audio's VP4 Virtual Pedalboard has been added to the wiki.
Difference between revisions of "Pitch block"
| Line 20: | Line 20: | ||
* Use the [[Ring Modulator (block)]] in tracking mode | * Use the [[Ring Modulator (block)]] in tracking mode | ||
* Set the Pitch block to Octave Divide. | * Set the Pitch block to Octave Divide. | ||
| + | |||
| + | ==Whammy== | ||
| + | Go to [[Controllers_and_modifiers#Modifier_curves]] | ||
==Position of the Pitch block== | ==Position of the Pitch block== | ||
Revision as of 07:16, 19 June 2012
Contents
Manual
Template:5.24 Pitch Shifter (PIT)
User contributions
What is pitch shifting
Learn feature
The Pitch block has a Learn function. Turn it on, play a note, hold it. The Axe-Fx II sets the key according to the note you played. Source
Detune
In general: detune up and down the same amount, between +/-5 and +/-10, delay the voices for more width (7ms), set mix at 25% or lower, place the block after the Amp block but before the Cab block, pan the voices hard left and right. Check for Phase cancellation when running in mono.
Octaver
If you need an Octaver effect (1 octave down voice), set the pitch shifter to Fixed Harmony, 1 octave down. Alternatives:
- Use the Ring Modulator (block) in tracking mode
- Set the Pitch block to Octave Divide.
Whammy
Go to Controllers_and_modifiers#Modifier_curves
Position of the Pitch block
Cliff: "When going direct, pitch shifting often sounds best when placed BEFORE the cab block. The factory presets may have the block doing the shifting (pitch or multidelay) after the cabinet block. Try moving the pitch before the cabinet block for smoother results." Background (source: Bakerman): "The pitch block basically shifts the entire cab freq. response up/down if it's after cab. A slight detune might sound about the same either way but with a half step, whole step, etc. the difference becomes more apparent."
Harmony scales
The manual contains a table with the harmony scales, see Harmony scales.
