Read the Owners Manual first!
Difference between revisions of "Phaser block"
| Line 4: | Line 4: | ||
=Phaser: supported by which Fractal Audio products= | =Phaser: supported by which Fractal Audio products= | ||
| − | * '''Axe-Fx II''': yes. | + | * '''Axe-Fx III''': yes (2x). |
| − | * '''AX8''': yes. | + | * '''Axe-Fx II''': yes (2x). |
| − | * '''FX8''': yes. | + | * '''AX8''': yes (1x). |
| + | * '''FX8''': yes (2x). | ||
| − | =Phaser: X/Y | + | =Phaser: X/Y switching or channels= |
| + | * '''Axe-Fx II''': yes (4 channels). | ||
* '''Axe-Fx II''': yes. | * '''Axe-Fx II''': yes. | ||
* '''AX8''': yes. | * '''AX8''': yes. | ||
Revision as of 12:19, 7 February 2018
The information on this page supplements the official manuals.
Contents
- 1 Phaser: supported by which Fractal Audio products
- 2 Phaser: X/Y switching or channels
- 3 Phaser: mono or stereo
- 4 Order parameter
- 5 Feedback Tap parameter
- 6 Thump when engaging the Phaser
- 7 Control the start of the Phaser sweep
- 8 Uni-vibe effect
- 9 Barber Pole Phaser type
- 10 More phaser effect information
Phaser: supported by which Fractal Audio products
- Axe-Fx III: yes (2x).
- Axe-Fx II: yes (2x).
- AX8: yes (1x).
- FX8: yes (2x).
Phaser: X/Y switching or channels
- Axe-Fx II: yes (4 channels).
- Axe-Fx II: yes.
- AX8: yes.
- FX8: yes.
Phaser: mono or stereo
Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting and place it after Drive, Amp and (mono) Cab.
Order parameter
Increase the Order parameter to simulate phasers such as the EHX Small stone and Mu-tron Bi-Phase.
Feedback Tap parameter
"There is no feedback on a Script 90." source
Thump when engaging the Phaser
If engaging/bypassing the Phaser block causes an audible thump or gap, change input impedance to 1M (Axe-Fx II and FX8).
Control the start of the Phaser sweep
If the parameter “LFO Bypass Reset” is set to anything other than “Off”, the LFO will be reset to the selected phase whenever the block is bypassed. This allows synchronizing the sweep to the engagement of the effect.
Uni-vibe effect
The Vibe effect is available as a special mode of the Phaser block. Set Vibe Mode to On (or select the Classic Vibe type). The default settings are modeled after the Fulltone Deja-Vibe. source
"You need it before the amp if you want the bump." source
Tip: connect a pedal or switch (via an external controller) to the Rate parameter to control speed.
More information about the Uni-Vibe.
Barber Pole Phaser type
This phaser type works best when placed at the end of the chain.
