Volume/Panner block

Vol/Pan: in the owner's manual

• Axe-Fx II: 5.33 Vol/Pan [VOL]

Vol/Pan: in which products?

• Axe-Fx II: yes.
• AX8: yes.
• FX8: yes.

Vol/Pan: audio tapers

• The Volume block offers various audio tapers. Cliff: "The number is the percentage at the halfway point. I.e. Log 20A means that the resistance is 20% at the halfway point in the travel. So if you put the knob at noon, the volume would be 20% of maximum (about -14 dB)." source
• To simulate a Log taper in a modifier menu, set "Mid" in the modifier menu to 20%. Adjust Slope to avoid the dead zone.

Vol/Pan: automating volume swells

• To automate volume swells (like a Boss Slow Gear pedal), use a Volume block at the start of the grid and attach Envelope to its Volume parameter. You can also copy the block and Envelope settings from a factory preset, such as Auto Swell Pongverb, Ganymede or Atmosphere. The Envelope's Attack parameter and the Volume block's Taper parameter determine the swell rate.
• Alternatively, for example to achieve Van Halen's Cathedral effect, set the input noise gate to a low threshold (i.e. -49), set ratio between 3.3 and 4, Attack and Release to 31 ms.

Vol/Pan: operate as a noise gate

• Tie the Volume parameter in a Volume block to Envelope. As long as you don't hit the strings, the input signal is off.

Vol/Pan: operate as a router/switcher

• The fact that the Volume block doesn't require much CPU makes it a good solution for routing scenarios. By setting its Bypass parameter to mute and placing it at the start of a certain routing, you can enable or disable a certain routing within a preset, depending on the state of the Volume block. You can set it per scene.

Vol/Pan: more information and tips

• FX8 and Axe-Fx II effects threads: Compression, Volume, Gate (CMP, VOL, GTE)