Read the Owners Manual first!
Difference between revisions of "Phaser block"
Jump to navigation
Jump to search
| Line 28: | Line 28: | ||
* [http://en.wikipedia.org/wiki/Phaser_(effect) Phaser in Wikipedia] | * [http://en.wikipedia.org/wiki/Phaser_(effect) Phaser in Wikipedia] | ||
| − | |||
| − | |||
| − | |||
[[category:Effect]] | [[category:Effect]] | ||
Revision as of 14:04, 23 March 2015
Contents
Manual
User contributions
Phaser: stereo/mono
- Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks.
Phaser: feedback tap parameter
- Cliff: "There is no feedback on a Script 90." Source
Phaser: preventing thump when engaging
- If engaging/bypassing the Phaser block causes an audible thump or gap, change Input Impedance to 1M.
Phaser: Uni-vibe effect
- The Vibe effect (Wikipedia) is a special mode of the Phaser block. Set Vibe Mode to On (or select the Classic Vibe type).
- Tip: connect a pedal or switch (via an external controller) to the Rate parameter to control speed.
- This thread contains excellent Robin Trower vibe settings.
Phaser: Barber pole
- This phaser type works best when placed at the end of the chain.
