Always consult the official Owners Manuals first!
March 2024: all pages have been checked and are up-to-date

Tremolo/Panner block

From Fractal Audio Wiki
Revision as of 11:32, 30 July 2019 by Yek (talk | contribs) (→‎Types)
Jump to navigation Jump to search

Tremolo block.png

Available on which products

  • Axe-Fx III: 2 blocks
  • FM3: yes @@
  • Axe-Fx II: 2 blocks
  • AX8: 1 block
  • FX8: 2 blocks

Channels or X/Y switching

  • Axe-Fx III and FM3: 4 channels
  • Axe-Fx II Mk I and II: no
  • Axe-Fx II XL and XL+: X/Y
  • AX8: X/Y
  • FX8: X/Y

Position of the Tremolo/Panner block on the grid

If the Tremolo block is placed before the Amp block and there's a lot of amp gain, the tremolo effect will be less noticeable because of the compression of the signal. Adjust the waveform or the Duty parameter to emphasize the pulse. Or move the Tremolo block to a position after the Amp block.

The Panner pans the signal left and right, just like a ping pong delay. This requires the signal not being summed to mono after the Tremolo/Panner block.

You can make the Panner effect appear “fuller” and “wider” by adding the Enhancer block after it.

Parameters

Parameters table

Parameter Axe-Fx III / FM3 Axe-Fx II AX8 / FX8
Type yes
Rate yes
Tempo yes
Depth yes
LFO Type yes
LFO Duty Cycle yes
LFO Phase yes
Start Phase yes
Crossover Slope, Freq yes
Panner — Width yes
Panner — Pan Center yes

LFO Phase

Set LFO Phase to 0 for mono output, and to any other value for stereo output.

Depth

There's no Mix parameter In the Tremolo block. Depth is the same as Mix, because a tremolo's modulation is volume-based.

"Mix makes no sense in a tremolo as it is the same as reducing the depth." source

Start Phase

You can start the Tremolo on the beat (triggered) by using the Start Phase parameter. This applies to engaging the effect, not to hitting the strings.

To align the Tremolo to the moment that you hit the strings, set Rate to “LFO1 SYNC”, sync LFO1 to a Tempo, and attach the LFO to the Envelope follower.

Duty

Use this parameter to change the character of the tremolo peaks, from a regular tremolo to electronic "blobs".

Tips and tricks

Tremolo in Amp block

The Amp block in the Axe-Fx II and III (not in the AX8 and FM3) provides its own Bias Tremolo.

Ring Modulator as a tremolo

You can configure the Ring Modulator block to operate as a tremolo, by turning down Frequency all the way.

Flanger as a tremolo

You can turn a Flanger block into a tremolo.

Shuffle tremolo

Create a "shuffle" tremolo