Always consult the official Owners Manuals first!
March 2024: all pages have been checked and are up-to-date

Spillover

From Fractal Audio Wiki
Jump to navigation Jump to search

About spillover

Spillover: when the trails of delay or reverb can still be heard after switching to another sound.

All FAS processors support spillover under certain conditions as explained in the manuals.

When switching presets

Spillover is enabled or disabled for preset switching in the Global menu. It requires additional steps to make it work, as explained in the manuals..

The setting in the Global menu applies to switching presets only, not to switching scenes, switching channels or bypassing blocks.

True, independent spillover is not supported because this would require double the processing power of each processor.

"Global spillover settings only apply to preset changes. Spillover between scenes is, in general, desirable and controlled by the bypass mode and state of the various blocks." source

When bypassing effects and switching scenes

The Global Spillover setting doesn't apply to spillover when turning off effects or switching scenes or channels. Delay and Reverb trails always ring out when switching scenes, depending on the effect block's Bypass Mode setting. This is inherent to the way scenes work. When it comes to spillover, scenes work better than presets and are easier to set up.

"Spillover is in there but the "right" way to do it is to use scenes. If you stay within a preset and use channels and scenes the spillover is perfect." source

Scene Controllers allow more control over what happens with the sound when changing scenes.

More information

The Multi Delay, Ten-Tap Delay, Plex Delay and Megatap Delay blocks don’t support spillover between preset switching.

Spillover can be affected when switching between the X/Y states or channels of an effect, if drastically different algorithms exist between the two states. For example, if one scene has a Digital Delay and the next scene uses a Tape Delay, spillover will probably not function correctly as these modes use different algorithms.

Forum member: "I have two patches that both has delay blocks disabled and when I switch between these patches via MFC the delay spillover sometimes kicks in really loud."

"This can happen if you rapidly switch between presets many times. The unit requires a small amount of time between preset changes to clear unused buffer space. This is done as a background task." source

If you use the Mix and Level parameters to dial in the desired effects level, the volume level of the reverb and/or delay trails may change when switching presets. This can be prevented by keeping Mix and Level at fixed values, and using Input Gain to set the desired effects level. source

Wicked Wiki article