Always consult the Owners Manuals and FAQs first.
FM3 information is being added as it becomes available, but it's preliminary and not final until release

Send and Return block

From Axe-Fx II Wiki
Revision as of 07:59, 6 August 2019 by Yek (talk | contribs) (Clipping Return Level)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Extend grid.PNG

Available on which products

  • Axe-Fx III: 2 pairs
  • FM3: yes @@
  • Axe-Fx II: 1 pair
  • FX8: no
  • AX8: no

Channels or X/Y switching

  • Axe-Fx III: no
  • FM3: no
  • Axe-Fx II: no

Purposes

Extend the signal chain on the grid

You can use Feedback Send/Return to connect the signal chain on the grid from one row to another. The Owner's Manual explains how this works.

Send Input 2 to Output 2 on the Axe-Fx II

Feedback Send and Return can be used to enhance the effects loop (FXL) on the Axe-Fx II.

By itself, FX Loop allows:

  • a signal from Input 2 to enter the grid
  • sending a signal through Output 2

By placing FXL inbetween Feedback Return and Feedback Send, you can accomplish both: send input from Input 2 to Output 2. Read this: FX Loop block

Delay loop

Create a delay feedback loop

Feedback loop.PNG

Parameters

Parameters table

Parameter Axe-Fx III / FM3 Axe-Fx II
Send - Send Level no yes
Send - Output Level no yes
Return - Return Level / Mix yes yes
Return - Output Level yes yes

Setting parameters

Axe-Fx II – Both blocks have parameters which need configuring. In most cases, you'll want Send to feed the Return block only, NOT to pass signal to the next block. So Send Level (which feeds Return) has to be at 100% and Output Level (which sends signal to the next grid block) stays at zero. In this case the Return block's Mix parameter (which receives signal from Send) should be 100% and Return Level (which sends signal to the next grid block) is 0 dB.

Axe-Fx III and FM3 – Feedback Send does not have any parameters to set. The signal to Feedback Return can be controlled with Mix in the Feedback Return block (default: 0). And if the signal is passed to the next block and needs adjustment, there are other tools to accomplish that, such as a Volume block.

"The reason the default level for the Return Block is 0 is probably so that when you insert it, you don't need to fear screaming feedback. The way it is, you can turn it up to make sure you haven't created a bad feedback loop. source

Clipping Feedback Return

"The feedback return will clip at extremely high input levels. This is a protection mechanism to prevent against "runaway" if someone creates a feedback loop. The feedback return clips at a level of 38 dBu. This is nearly 10 times the maximum output level of the unit. If this protection were not there a feedback loop could be created that would result in digital overflow and cause a reboot." source