Always consult the Owners Manuals and FAQs first.
FM3 information is being added as it becomes available, but it's preliminary and not final until release
Difference between revisions of "Phaser block"
|Line 18:||Line 18:|
* '''FX8''': X/Y
* '''FX8''': X/Y
Revision as of 10:56, 29 July 2019
- 1 Available on which products
- 2 Channels or X/Y switching
- 3 Phaser effects
- 4 Mono or stereo Phaser
- 5 Parameters
- 6 Thump when engaging the Phaser
Available on which products
- Axe-Fx III: 2 blocks
- FM3: yes @@
- Axe-Fx II: 2 blocks
- AX8: 1 block
- FX8: 2 blocks
Channels or X/Y switching
- Axe-Fx III and FM3: 4 channels
- Axe-Fx II: X/Y
- AX8: X/Y
- FX8: X/Y
These are based on the MXR Phase 90 and Phase 45, Script and Block versions.
The "Phase 45" type uses subtle two-stage phasing, while the "Phase 90" type uses more pronounced four-stage phasing.
The "Script" type has a more subdued sound with higher headroom and greater clarity. The "Block" type is more modern and relies on internal feedback to create light harmonic distortion and give the effect a more accentuated swoosh.
The Uni-Vibe effect is available as a special mode of the Phaser block. Engage the Vibe mode (or select the Classic Vibe type).
The default settings are modeled after the Fulltone Deja-Vibe. source
Put the effect before the Amp block.
"You need it before the amp if you want the bump." source
Connect a pedal or switch to the Rate parameter to control speed.
Like the "Shepard" tone, this creates the illusion of a never-ending upwards cycle. Works best when placed at the end of the chain.
Set the Phaser to 6 stages to emulate a Mutron Bi-Phase.
"For the double-phaser of the original, set it to 12-stage with LFO Phase at 0." source
Set Depth to 0, attach Frequency Start to the Sequencer. Set Min and Max and adjust the Sequencer faders.
Mono or stereo Phaser
Phaser defaults to mono to prevent phase problems when used before an Amp block.
To make it stereo, change the LFO Phase setting and place it after Drive, Amp and Cab.
|Parameter||Axe-Fx III / FM3||Axe-Fx II||AX8 / FX8|
|LFO Reset on Bypass||yes|
|Barberpole — Sweep Direction||yes|
|Barberpole — Filter Q||yes|
"Phasers cause notches in the spectrum which can reduce the apparent volume. It depends on the frequency content. Overdriven sounds have more content and will be affected more. The Level knob allows you to compensate for this."
Increase the Order parameter to simulate phasers such as the EHX Small stone and Mu-tron Bi-Phase.
"There is no feedback on a Script 90." source
LFO Bypass Reset
If LFO Bypass Reset is set to anything other than Off, LFO will be reset to the selected phase whenever the block is bypassed. This allows synchronizing the sweep to the engagement of the effect.
"Another fun phaser trick is to set DEPTH to 0 and assign the Frequency Start to an expression pedal." source
Thump when engaging the Phaser
Engaging some effects, like Wah or Phaser, can cause a "thump" in the sound. This may be caused by impedance switching. To solve this, change Input Impedance from "Auto" to "1M". The above doesn't apply to Fractal Audio processors with a fixed (not adjustable) input impedance. More information