Search results

Create the page "Panner effect" on this wiki! See also the search results found.

• Tremolo/Panner block
  =Tremolo/Panner types= ; Panner : Stereo panning between left and right.
  6 KB (986 words) - 16:00, 16 April 2024
• Enhancer block
  * The forum's <q>[http://forum.fractalaudio.com/threads/double-tracking-effect-on-live-guitar.119376 Live double tracking]</q> thread. ...ut and High Cut parameters allow control over the region of influence. The effect is mono-compatible: there are no phasing problems when summing to mono.
  6 KB (841 words) - 14:31, 9 April 2024
• Effects list
  The table below displays the available effect blocks per product. | Tremolo/Panner (2)
  4 KB (503 words) - 14:50, 5 February 2024
• Mono and stereo signal
  * The preset must contain at least one stereo effect, and ...eo output). When a Cab block is operating in stereo but followed by a mono effect such as Drive, the resulting signal will also be summed to mono.
  5 KB (844 words) - 22:53, 1 March 2024
• Expression pedals and external switches
  In those cases, the effect's bypass state after powering on depends on multiple factors such as the PC To set up a volume pedal in a preset, read [[Volume/Panner block]].
  14 KB (2,330 words) - 22:25, 29 March 2024
• Noise gate
  ...ects like audio swells (substitute for the Auto-Swell type in the [[Volume/Panner block]]. ...the preset is set to “Off”, the global Noisegate Offset value will have no effect. The default value is 0 dB and is set to that upon a system reset.
  14 KB (2,052 words) - 17:09, 5 April 2024
• Presets
  * Re-use effect blocks with preferred settings and levels, through [[Global blocks]] or the ...ects in front of Amp and Drive blocks should not be set to stereo. Certain effect blocks, such as Amp, Drive and mono Cab, sum the signal to monoaural. Check
  64 KB (10,468 words) - 23:06, 18 April 2024
• MIDI SysEx
  ...ect-bypass-status-info-available.html SysEx commands for retrieving Preset/Effect bypass states] ...ormation about each effect block in preset follows, using 5 bytes for each effect block in the preset
  114 KB (16,586 words) - 23:11, 24 December 2023
• Firmware release notes - FM9
  .... Typical plates are around 25-50%. Set to higher values to exaggerate the effect. Stereo imaging is adjustable via the “Pickup Spacing” parameter. ** The Optical Tremolo algorithm used in the Tremolo/Panner block has been completely rewritten and now has three types:
  50 KB (7,888 words) - 18:24, 15 April 2024
• FAMC Liquid Foot+
  # Tremolo/Panner 1 # Tremolo/Panner 2
  125 KB (20,342 words) - 08:20, 25 March 2022
• Factory presets
  The presets were dialed in loud so as to be sure the Fletcher-Munson effect did not influence the sound. ...e of a piezo-equipped guitar. An LFO-controlled Pitch block reproduces the effect of a TC Mimiq pedal (double tracking). The FM3 version is simplified. FM3 a
  97 KB (15,554 words) - 23:30, 21 April 2024
• Firmware release notes - Axe-Fx II
  ...s driven and is more noticeable as the MV is increased. Also note that the effect in real amps is highly dependent on the speaker. Some speaker/transformer c * Change “Thru” bypass mode so that effect input is muted. This prevents, for example, delays from creating echoes whe
  194 KB (31,845 words) - 17:59, 14 February 2024
• Amp block
  * Recall Effect (if supported by your device) — load the values of an AMP block from one ...nsformer orientation, phase of the moon, etc. And while these do have some effect, it is arguably inconsequential relative to the single biggest source of de
  431 KB (68,296 words) - 14:58, 20 April 2024