Search results

Create the page "Formant effect" on this wiki! See also the search results found.

• Formant block
  =About the Formant block= The Formant filter models human vowel sounds.
  2 KB (362 words) - 23:50, 26 February 2024
• Effects list
  The table below displays the available effect blocks per product. | Formant
  4 KB (503 words) - 14:50, 5 February 2024
• Wah block
  ...ller to the Wah's CONTROL parameter. For a more pronounced effect, add a [[Formant block]], attached to the same controller. ...to the Control parameter in the Wah block to create a slow evolving filter effect. Try the "[[Factory_presets|VELVET SUN]]" factory preset on for size.
  7 KB (1,086 words) - 16:06, 16 April 2024
• Pitch block
  The devices offer several ways to create an Octaver (octave down) effect: ...irl</q> associated with 80's chorus tone. Use it in stereo for a very wide effect. Van Halen's sound on the <q>Balance</q> album is well-known example of ste
  31 KB (4,751 words) - 16:15, 16 April 2024
• Impulse responses (IR)
  ...quency then you need fine frequency resolution to reproduce that. An 80 Hz formant with a Q of 3 only spans about 25 Hz. Obviously a frequency resolution of 4 ...ormant. There are some room reflections but they are very small. The 80 Hz formant starts well before any reflections. It's obviously a high-Q resonance as it
  71 KB (11,651 words) - 13:58, 20 April 2024
• Presets
  * Re-use effect blocks with preferred settings and levels, through [[Global blocks]] or the ...ects in front of Amp and Drive blocks should not be set to stereo. Certain effect blocks, such as Amp, Drive and mono Cab, sum the signal to monoaural. Check
  64 KB (10,468 words) - 23:06, 18 April 2024
• FAMC Liquid Foot+
  # Formant 1 # Formant 2
  125 KB (20,342 words) - 08:20, 25 March 2022
• MIDI
  ...loading presets, enable mapping of Program Changes, and choose between two Effect Bypass modes. The MIDI settings are part of the system data which can be ba * FORMANT BYP 58
  43 KB (6,811 words) - 05:58, 1 March 2024
• Firmware release notes - FM3
  ...100%, (e.g. wah, EQ, etc.) The new feature smooths the transition when the effect is turned on or off. ...m some switch configurations when viewed from the front panel, such as for Effect->Chan Inc/Dec.
  48 KB (7,631 words) - 16:33, 15 April 2024
• MIDI SysEx
  ...ect-bypass-status-info-available.html SysEx commands for retrieving Preset/Effect bypass states] ...ormation about each effect block in preset follows, using 5 bytes for each effect block in the preset
  114 KB (16,586 words) - 23:11, 24 December 2023
• Factory presets
  The presets were dialed in loud so as to be sure the Fletcher-Munson effect did not influence the sound. ...e of a piezo-equipped guitar. An LFO-controlled Pitch block reproduces the effect of a TC Mimiq pedal (double tracking). The FM3 version is simplified. FM3 a
  97 KB (15,554 words) - 23:30, 21 April 2024
• Firmware release notes - Axe-Fx III
  .... Typical plates are around 25-50%. Set to higher values to exaggerate the effect. Stereo imaging is adjustable via the Pickup Spacing parameter. ...curve resulting in a clearer low end. New algorithm now also accounts for effect of speaker impedance on transformer response.
  134 KB (21,544 words) - 17:43, 19 April 2024