Search results

Create the page "FXL block" on this wiki! See also the search results found.

• FX Loop block
  * '''Axe-Fx II''': 1 block * '''AX8''': 1 block
  6 KB (1,108 words) - 14:50, 5 February 2024
• Effects list
  | FXL | FXL
  4 KB (503 words) - 14:50, 5 February 2024
• Send and Return blocks
  You can use the Send/Return blocks to create a feedback loop with a Delay block. ...end/Return blocks can be used to enhance the [[FX_Loop_block|effects loop (FXL)]] on the Axe-Fx II.
  4 KB (573 words) - 11:44, 9 April 2024
• Output block
  * '''Axe-Fx II''', '''AX8''': not a block =About the Output block=
  4 KB (701 words) - 14:46, 2 March 2024
• Comparing the Axe-Fx II, AX8 and FX8
  ...y much "Axe-Fx Lite". All the advanced parameters are available in the amp block, you access them via the traditional edit menu. The dedicated Bass, Mid, et ...-blocks.108864/#post-1302595] The AX8 was not designed for use with Global Block. </blockquote>
  14 KB (2,317 words) - 19:44, 15 February 2024
• MIDI SysEx
  For example if you select a block on the Axe FX II, say, the Filter block, and you change the gain, then the Axe FX will send this message. ...message is also sent if you press a footswitch that changes a scene/preset/block bypass/XY.
  114 KB (16,586 words) - 23:11, 24 December 2023
• Presets
  * Adjust the desired [[Input impedance]] in the [[Input block]] if needed and supported by the processor. * When using one Amp block on an Axe-Fx: use AMP 1, not AMP 2.
  64 KB (10,468 words) - 23:06, 18 April 2024
• I/O connectivity and levels
  ...get out (assuming all unity-gain blocks in the chain). If you have an amp block in the chain then you have tons of gain and therefore no longer have unity * If you’re going to change a block’s BYPASS MODE from the default setting of THRU, it is best to check its l
  155 KB (25,257 words) - 16:49, 16 April 2024
• Cab block
  * '''Axe-Fx III''': 2 blocks (4 IRs per block) * '''FM9''': 2 blocks (2 IRs per block)
  86 KB (13,616 words) - 11:55, 23 April 2024