Search results

Create the page "Envelope filter effect" on this wiki! See also the search results found.

• Plex Delay block
  The Plex Delay is a dedicated effect block on the Axe-Fx III, FM9 and FM3. It provides up to 8 delay lines in a # Shimmer Verb — shimmer effect, see below
  4 KB (600 words) - 20:06, 2 March 2024
• Filter block
  =Filter types= A filter is a very versatile effect. Examples include:
  8 KB (1,206 words) - 20:10, 26 February 2024
• Multitap Delay block
  # Comb Filter Delay ...n you select it. Try the following settings for a lush reverb-like blanket effect.
  5 KB (806 words) - 16:50, 16 April 2024
• Tremolo/Panner block
  ...he left/right which can be used to achieve unique sounds. Furthermore, the effect supports LFO types other than Sine for even more unique sound. ...is placed before the Amp block and there's a lot of amp gain, the tremolo effect will be less noticeable because of the compression of the signal. Adjust th
  6 KB (986 words) - 16:00, 16 April 2024
• Comparing the Axe-Fx III to the Axe-Fx II
  ...s the same as "Fast RMS" in the AX8 and Axe-Fx II. "E-L Panel" mode added. Filter parameter has been replaced with EQ-ing tools. More compressor types, susta * Some effects have their own envelope follower, such as Plex Delay
  10 KB (1,519 words) - 17:47, 16 April 2024
• Pitch block
  The devices offer several ways to create an Octaver (octave down) effect: ...octave divider algorithm is just a synthesizer with an aggressive lowpass filter (it simply generates two square waves based on the frequency of the global
  31 KB (4,751 words) - 16:15, 16 April 2024
• Noise gate
  ; Modern Expander : Uses a novel approach to the envelope detector resulting in improved ballistics compared to traditional analog ex ...the preset is set to “Off”, the global Noisegate Offset value will have no effect. The default value is 0 dB and is set to that upon a system reset.
  14 KB (2,052 words) - 17:09, 5 April 2024
• Factory presets
  The presets were dialed in loud so as to be sure the Fletcher-Munson effect did not influence the sound. ...— Fender Tweed Deluxe, Tube Screamer, PI Fuzz. Rotary speed is tied to the envelope controller.
  97 KB (15,554 words) - 23:30, 21 April 2024
• Presets
  * Re-use effect blocks with preferred settings and levels, through [[Global blocks]] or the ...ects in front of Amp and Drive blocks should not be set to stereo. Certain effect blocks, such as Amp, Drive and mono Cab, sum the signal to monoaural. Check
  64 KB (10,468 words) - 23:06, 18 April 2024
• Firmware release notes - FM3
  * Fixed a filter issue affecting the Wah block. ** Added “Modern Expander” type. This uses a novel approach to the envelope detector resulting in improved ballistics compared to traditional analog ex
  48 KB (7,631 words) - 16:33, 15 April 2024
• Firmware release notes - FM9
  .... Typical plates are around 25-50%. Set to higher values to exaggerate the effect. Stereo imaging is adjustable via the “Pickup Spacing” parameter. * AMP effect now has 32 less sample times of latency.
  50 KB (7,888 words) - 18:24, 15 April 2024
• Impulse responses (IR)
  ...world IRs are obtained from real speakers and when processed using an FIR filter produce extremely accurate results. In essence an IR is a "sample" of the s ...chniques for creating a cascade of second-order sections (SOS) from an FIR filter (Prony's method is one).
  71 KB (11,651 words) - 13:58, 20 April 2024
• Firmware release notes - Axe-Fx III
  .... Typical plates are around 25-50%. Set to higher values to exaggerate the effect. Stereo imaging is adjustable via the Pickup Spacing parameter. Fixed a filter in the Wah block not being initialized.
  134 KB (21,544 words) - 17:43, 19 April 2024
• Amp block
  * Recall Effect (if supported by your device) — load the values of an AMP block from one ...nsformer orientation, phase of the moon, etc. And while these do have some effect, it is arguably inconsequential relative to the single biggest source of de
  431 KB (68,296 words) - 14:58, 20 April 2024
• Drive block
  ...trap, gear, etc. algorithms. It dampens numerical ringing without the side-effect of damping actual circuit ringing. Once you see how it works it seems hard ...log" and feel better. The old algorithm is the classic filter->waveshaper->filter technique. It's okay but I've long moved beyond waveshapers in amp modeling
  264 KB (42,788 words) - 13:40, 18 April 2024