The VP4 has been added to the wiki.

Mono and stereo

From Fractal Audio Wiki
Revision as of 10:46, 12 October 2015 by Yek (talk | contribs)
Jump to navigation Jump to search

Mono/Stereo: in the owner's manuals

  • Axe-Fx II: 5.9 Enhancer [ENH].
  • Axe-Fx II: 9.2 Audio Parameters.
  • Axe-Fx II: 16.10 Mono and Stereo.
  • AX8: ...
  • FX8: 1 Introduction.

Play mono or stereo?

  • There will always be discussions. Here's an example. Effets sound gloriously in stereo. However, when it comes to FOH sound, stereo separation may not translate very well to a live audience, because people seldom are in the right spot to hear both sides equally well.

Mono/Stereo mode can vary per output

  • The Axe-Fx, AX8 and FX8 provide different mono/stereo modes (I/O menu) for each output.
  • Sum L+R and Copy L>R are mono modes.

Effect blocks and mono/stereo output

  • Flanger, Chorus and Phaser are set to mono by default. Use the parameter LFO Phase to switch the effect to stereo.
  • Everything before an AMP block or Drive block will be summed to mono.
  • When placing a Cab block at the end of the grid, the output signal will be summed to mono, unless the Cab is set to Stereo mode (or when two mono Cab blocks are used in parallel). When a Cab block is set to Stereo mode, but it is followed by a mono effect such as Drive, the resulting signal is also summed to mono.

Beware of phase cancellation when summing output to mono