The VP4 has been added to the wiki.
Difference between revisions of "Phaser block"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
=Phaser: in the owner's manual= | =Phaser: in the owner's manual= | ||
* [[media:5.23 Phaser -PHA-.pdf |Axe-Fx II: 5.23 Phaser [PHA]]] | * [[media:5.23 Phaser -PHA-.pdf |Axe-Fx II: 5.23 Phaser [PHA]]] | ||
| + | |||
| + | =Phaser: in which products?= | ||
| + | * Axe-Fx II: yes. | ||
| + | * AX8: yes. | ||
| + | * FX8: yes. | ||
=Phaser: stereo or mono= | =Phaser: stereo or mono= | ||
Revision as of 19:36, 1 April 2015
Contents
Phaser: in the owner's manual
Phaser: in which products?
- Axe-Fx II: yes.
- AX8: yes.
- FX8: yes.
Phaser: stereo or mono
- Phaser defaults to mono to prevent phase problems when used before an Amp block. To make it stereo, change the LFO Phase setting, and place it after Drive, Amp and mono Cab blocks.
Phaser: Feedback Tap parameter
- Cliff: "There is no feedback on a Script 90." source
Phaser: preventing thump when engaging
- If engaging/bypassing the Phaser block causes an audible thump or gap, change Input Impedance to 1M.
Phaser: Uni-vibe effect
- The Vibe effect is a special mode of the Phaser block. Set Vibe Mode to On (or select the Classic Vibe type).
- Tip: connect a pedal or switch (via an external controller) to the Rate parameter to control speed.
- Excellent Robin Trower vibe settings
Phaser: Barber pole
- This phaser type works best when placed at the end of the chain.
