The VP4 has been added to the wiki.
Difference between revisions of "Mono and stereo"
Jump to navigation
Jump to search
m (moved Output: mono or stereo to Output: mono/stereo) |
|
(No difference)
| |
Revision as of 09:37, 23 October 2012
Contents
Manual
User contributions
Mono or stereo?
There always be discussions about this. The Axe-Fx II sounds gloriously in stereo. However, that experience will not always translate very well to a live audience, because people seldom are in the right spot to hear both sides equally well.
Different mode for each output
The Axe-Fx II makes it possible to have different mono/stereo modes for each of the outputs.
Effect blocks
- Flanger, Chorus and Phaser are set to mono by default. Use the parameter LFO Phase to switch the effect to stereo.
- Everything before an Amp block (and a mono Cab, Drive or Compressor block) will be summed to mono.
Phase cancellation
Summing a stereo signal to mono may cause Phase cancellation.
