Leslie emulation

From Fractal Audio Wiki
Revision as of 15:19, 19 December 2007 by Scarr (talk | contribs) (modified link after Axechange.net was updated)
Jump to navigation Jump to search

If you want to emulate a Leslie or Vibrotone using the Axe-Fx, there are three key components: slow speed, fast speed and the ramp between them. The latter is optional based on how authentic you want to be, but this is a guide at how to recreate the effect.

According to a page I found, the Leslie speeds are 40 and 390 RPM. Diving by 60, that translates to .67 Hz and 6.5Hz, respectively. We'll use these values to set our rate modifier. The only decent way I know to translate values to modifier ranges is to carefully check the position of the knob at the START and END points you are interested in and then eyeball the modifier values.


Fortunately, the Axe-Fx makes setup easy:

  • Hit ENTER on the RATE control to assign a modifier
  • Choose the SOURCE expression pedal (or whatever you want to control it)
  • Put the pedal in the initial, heel down position
  • Page down until START is highlighted
    • set a value (5.9% for the .67 Hz)
    • hit EXIT
    • check position of the knob
    • hit ENTER and repeat sub-steps as needed
  • Page down until END is highlighted
    • set another value (64.6% for 6.5 Hz)
    • hit EXIT
    • check position of the knob
    • hit ENTER and repeat sub-steps as needed
  • Set MID somewhere in between (35% rough midpoint)
  • Set DAMPING control to 1.000 second to simulate the Leslie's rise time
  • Hit EXIT. You're done!


When complete, the effect should sound something like this. If you're very lazy, you can just download the patch used to record it.


If you want other cabinets' numbers, I found these:

  • Leslie (16?): 40 - 390 RPM (.67 - 6.5 Hz)
  • Measured on a Leslie 147:
    • Top rotor: 48 - 400 RPM (.8 - 6.67 Hz)
    • Lower drum: 40 - 342 RPM (.67 - 5.7 Hz)
  • Measured on a Fender Vibrotone: 40 - 340 RPM (.67 - 5.67 Hz)