Always consult the official Owners Manuals first

Enhancer block

From Fractal Audio Wiki
Revision as of 08:38, 14 March 2018 by Yek (talk | contribs)
Jump to navigation Jump to search

Image to be added.

Stereo Enhancer: supported by which Fractal Audio products

  • Axe-Fx III: 2x.
  • Axe-Fx II: 1x.
  • FX8: 1x.
  • AX8: 1x.

Stereo Enhancer: X/Y switching or channels

  • Axe-Fx III: 2 channels.
  • Axe-Fx II: no.
  • FX8: no.
  • AX8: no.

Classic or Modern mode

  • Classic: old Haas effect delay-based processing. Haas effect in Wikipedia.
  • Modern: multi-band techniques for a much more natural effect. Also, the effect is mono-compatible with no phasing problems when summing to mono. The effect both widens stereo signals and “stereoizes” mono signals. Low-cut and High-cut parameters allow control over the region of influence. It is NOT recommended to use the Enhancer if just using one side of a stereo output as phasing effects may be encountered. More information.

"Classic enhancer mode is just a delay on one side (adjustable from 0 to 20 ms) plus pan & phase adjustment. The non-delayed side will tend to seem louder, just like if you used a delay block to get the same delay time." Bakerman

Input and output: mono/stereo

  • Output: The Enhancer only works with stereo output. Also, don't use it if you only use one channel (left or right) of a stereo signal.
  • Input: While a stereo input signal works best, the Enhancer can also "stereoize" an incoming mono signal. Of course, the output signal still has to be stereo.

Tips and tricks

Widen the Panner

Make the stereo Panner (Tremolo/Panner block) effect appear fuller and wider by adding the Enhancer.

Alternatives to Stereo Enhancer

"Another way would be to use the Delay block. Set the Mix to 100%, dial in the desired amount of delay and set Balance to full right." source

Troubleshooting

Avoid phase cancellation and comb filtering

When summing a stereo signal to mono, the Enhancer in Classic mode can cause phase cancellation. The Modern Mode is mono-compatible to prevent this.

"Never put the enhancer in parallel or you'll get phasing problems. That's why there is no bypass mode because it should always be in series." source

"The Modern Enhancer will survive collapsing to mono but any enhancer should be used judiciously, especially for recordings." source

More information.

More information about the Stereo Enhancer